Magnitude 4.3 Earthquake Saturday near Whitesburg, KY

An earthquake has been felt moderately by numerous persons across southeast Kentucky. Slight damage has been reported. Damage reports so far have included objects falling from shelves and some gas line leaks and water main breaks in the city of Hazard.

The National Earthquake Information Center has indicated that the magnitude 4.3 earthquake on the Richter Scale occurred at 1208 pm EST at 37.161ºN/83.034ºW, or about 8 miles west of Whitesburg, KY. The earthquake was centered 12.4 miles deep. At least one aftershock of magnitude 2.5 on the Richter Scale has occurred.

Any further information will be made available when it is received from the National Earthquake Information Center in Golden, Colorado. The National Earthquake Information Center information is available on the internet at

Earthquakes in the Stable Continental Region

Most of North America east of the Rocky Mountains has infrequent earthquakes. Here and there earthquakes are more numerous, for example in the New Madrid seismic zone centered on southeastern Missouri, in the Charlevoix-Kamouraska seismic zone of eastern Quebec, in New England, in the New York - Philadelphia - Wilmington urban corridor, and elsewhere. However, most of the enormous region from the Rockies to the Atlantic can go years without an earthquake large enough to be felt, and several U.S. states have never reported a damaging earthquake. The earthquakes that do occur strike anywhere at irregular intervals.

Earthquakes east of the Rocky Mountains, although less frequent than in the West, are typically felt over a much broader region. East of the Rockies, an earthquake can be felt over an area as much as ten times larger than a similar magnitude earthquake on the west coast. A magnitude 4.0 eastern U.S. earthquake typically can be felt at many places as far as 100 km (60 mi) from where it occurred, and it infrequently causes damage near its source. A magnitude 5.5 eastern U.S. earthquake usually can be felt as far as 500 km (300 mi) from where it occurred, and sometimes causes damage as far away as 40 km (25 mi).


Earthquakes everywhere occur on faults within bedrock, usually miles deep. Most of the region's bedrock was formed as several generations of mountains rose and were eroded down again over the last billion or so years.

At well-studied plate boundaries like the San Andreas fault system in California, often scientists can determine the name of the specific fault that is responsible for an earthquake. In contrast, east of the Rocky Mountains this is rarely the case. All parts of this vast region are far from the nearest plate boundaries, which, for the U.S., are to the east in the center of the Atlantic Ocean, to the south in the Caribbean Sea, and to the west in California and offshore from Washington and Oregon. The region is laced with known faults but numerous smaller or deeply buried faults remain undetected. Even most of the known faults are poorly located at earthquake depths. Accordingly, few earthquakes east of the Rockies can be linked to named faults. It is difficult to determine if a known fault is still active and could slip and cause an earthquake. In most areas east of the Rockies, the best guide to earthquake hazards is the earthquakes themselves.



Return to News Archive is the U.S. government's official web portal to all federal, state and local government web resources and services.